Press the
The Sport Dog Trainer will perform the following operations:
1. Check for low batteries in both the transmitter and receiver
2. Verify that the User Identification Codes match in both the transmitter
and receiver
3. Remind you what intensity level the receiver is set to
The table below lists each operation with its response once the
"Test/Tone" button is pressed.
button located on the keypad of the transmitter.
Response
Operation
Good Batteries = Transmitter LED will be solid
in color while the "Test/Tone" button is pressed.
Low Batteries = LED will not light up
Check for low batteries
in the transmitter
Good Battery = Receiver will beep according to
the setting of the intensity level (one time = low
to 4 times = very high).
Good Battery = Receiver LED solid green in color
Low Battery = Receiver will not beep and the
LED will solid red in color
Check for low battery
in receiver
Matching = receiver will perform function as
"good battery"
Not Matching = Receiver will not beep
User Identification
Code not matching
Will correspond to the number of beeps made
by the speaker located inside the receiver
Intensity Level
By pressing any of the stimulation buttons and looking at the test
light, you verify the following:
1. The Dog 1/2 switch is set correctly.
2. The stimulation circuitry is functioning properly.
If the test light did not light up when any of the stimulation buttons
were pressed, refer to "Troubleshooting the Sport Dog Trainer."
(See page 10).
B. Placing the Receiver Collar on Your Dog
• Before placing the Sport Dog Trainer on your dog, be sure to
wash your dog’s neck and collar’s probes with antibacterial soap.
Do this at least once a week to prevent irritation.
10
400-158-11/B
5/4/00, 10!32 AM
10-11
