www.petsafe.net 5
7. Drill the 4 corners all the
way through the inside
and outer walls. Use a
5
/
16
" drill bit, and use the
framing square to be sure
you keep the drill level
and perpendicular to the
wall (
1F).
8. Carefully cut the hole
out using a jigsaw or
other appropriate cutting
device (
1G).
Note: Cut on line.
9. Using the Inside Frame
A, check the fit (
1H). Do
not force if the fit is too
tight. If the hole is too
small, simply remove the
Inside Frame and re-cut
or file the hole slightly to
enlarge (
1I). Do not cut
more than
1
/
8
" from your
previous cut.
10. Once the Inside Frame
properly goes into the
hole, adjust to ensure the
unit is square.
11. Move outdoors and
repeat the process. For
1H
1I
5/16"
1F
1G
fitting the Outside Frame B use the previously drilled holes as your corners. Always check that
your lines are plumb (vertical) and level (horizontal). Remember to measure frequently, so you
only need to cut once.
Summary of Contents for SmartDoor MPA11-12019
Page 10: ...10 1 800 732 2677...
Page 11: ...www petsafe net 11...