• Attach the mirror to the wall by locating over the
screw heads. Ensure the screw heads are fully
engaged into the hanging slots.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• Activate your new LED mirror by swiping your hand in
front of the sensor.
Commissioning
Instruction leaflet
Merle Mirror
60898
www.saxbylighting.com
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting. BH23 3PE
• We recommend cleaning with a soft dry cloth. Do
not use solvents or abrasive cleaners as these could
damage the finish.
• Mirror – Use a damp cloth or a propriety glass
cleaner. Do not use abrasive materials as these will
damage the finish.
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
Iss.1 02072015
Having correctly identified the wiring from your existing
light fitting, fit the cable into the cable clamp and through
the black rubber grommet. Connect to the connection
block inside the product in the following way:
Wiring
Check that...
• You have correctly identified the wires
• The connections are tight
• No loose strands have been left out of the connection
block.
• The cable clamp is secured over the cable.
