8
+1 (800) 732-2677
petsafe.com 9
Do not install the battery while the receiver collar is on
your pet.
If the receiver indicator light is flashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the receiver
collar. Discharge all power by holding the correction level button down
until the light is no longer illuminated. Replace with a new battery.
Be sure to discard the used battery properly.
A replacement 9-volt alkaline battery (PAC11-12067) can be found at
many retailers. Contact the Customer Care Center or visit our web site
to locate a retailer near you.
Prepare the Receiver Collar
Your receiver collar comes with short contact
points installed. The long contact points should be
used on dogs with long hair. Tighten the contact
points using the test light Tool (A) one-half turn
beyond finger tight. Check the tightness weekly.
Insert/Remove the Battery
1. Remove the screws with a Phillips
screwdriver.
2. Remove the battery lid (
B
).
3. Install a 9-volt alkaline battery (
C
).
4. Replace the battery lid (
C
).
5. Reinstall the screws. Do not over-
tighten the screws.
A
B
C
