Petsafe PBC45-13339, Operating Manual

Page: 78 / 88

78 www.petsafe.net
FI
SV
DA
NO
RU
EN
6. Trim the collar as follows ( D ):
a. Mark the desired length of
the collar with a pen. Allow
for growth if your dog is
young or grows a thick
winter coat.
b. Remove the Bark Control
Collar from your dog and cut
off excess.
c. Before placing the Bark Control Collar back onto your dog, seal the edge of the
cut collar by applying a flame along the frayed edge.
ON/OFF Battery Module
The PetSafe
®
VBC-10 Vibration Bark Control is packaged with the battery module
installed in the “OFF“ position. To activate the collar, use a coin to turn the Battery
Module counter clockwise until the arrow lines up with the “ON“ position. If the collar is
not going to be used on the dog immediately leave it in the “OFF“ position.
To Insert and Remove the Battery
Note: Do not install the battery while the Bark
Control Collar is on your dog.
1. Align the line on the battery with the triangle
on the Bark Control Collar (
A
).
2. Use a coin to turn the battery clockwise
until the line points to the “ON“ position if
you are putting it on the dog or the “OFF“
position if it is not being put on the dog
right away ( B ).
3. To remove the battery, turn the battery anti-
clockwise using a coin ( C, D ).
Do not attempt to cut into or pry open the battery. Be sure
to discard the used battery properly.
D
D C
A B