DE
NL
IT
FR
ES
EN
www.petsafe.net 13
12 www.petsafe.net
Installation in a Non-Glass Door
Door
STEP 1
Determine Dog Door Location
Note:
Disconnect Power Adaptor from Dog
Door (or remove optional rechargeable
battery if using) and disconnect the Motion
Sensor Wire from Exterior Frame prior
to installation.
Measure and mark your dog’s belly height on
the interior side of door. Draw a level line at
your dog’s belly height (
Fig. 1A
).
Determine location for the Dog Door. Draw a
vertical centre line through the belly height line using a level (
Fig. 1B
).
Helpful Tip:
Mark belly height and vertical centre line lightly with a pencil or on a piece of tape so marks can easily be erased or removed.
STEP 2
Preparing Door
Match the marked lines on the door with the belly height and centre lines on the cutting template. Tape the
cutting template in place and carefully trace cutting template. Make sure to trace underneath tape and connect
the corners. Remove the cutting template and any excess tape from the door (
Fig. 2A
).
1A
1B
NOTICE
• Read this entire guide prior to cutting or modifying an
opening in your door or wall. Do not proceed with cut-out
or installation until your Dog Door is assembled, powered
up, programmed for your dog, and all steps under
“Prepare, Setup and Test” have been completed.
•
If homeowner’s door or other application is not level, the
Dog Door must be installed level to swing properly.
2A
NOTICE
When applying cutting template there should be a minimum of 8 cm between the bottom and sides of
the door and the outer edge of the cutting template to maintain the structural integrity of the door.
