18
+1 (800) 732-2677
petsafe.com 19
To Cross Hard Surfaces (driveways, sidewalks, etc.)
Follow all safety instructions for your power tools. Be sure to always wear your safety goggles.
• Concrete Driveway or Sidewalk (7C):
Place the
Boundary Wire in a convenient expansion joint
or create
a groove using a circular saw and masonry blade. Place
the Boundary Wire in the groove and cover with an
appropriate waterproofing compound. For best results,
brush away dirt or other debris before patching.
• Gravel or Dirt Driveway (7D):
Place the Boundary Wire
in a PVC pipe or water hose to protect the Boundary
Wire before burying.
7C
7D
Place the Boundary Flags
The Boundary Flags are visual reminders for your pet of where the Warning Zone is located.
1. Place the Test Light contacts on the contact
points and hold the Receiver Collar at your
pet’s neck height.
2. Walk towards the Warning Zone until the
Receiver Collar beeps (
8A
).
3. Place a Boundary Flag in the ground (
8B
).
4. Walk back into the Pet Area until
the beeping stops.
5. Repeat this process around the Warning Zone
until it is marked with Boundary Flags
every 10 feet.
Note: If you cannot hear the beep, see the
Test Light Instructions in Step 6.
Boundary
Wire
8A
8B
To prevent an unintended correction, after the Boundary Flags have been placed, be sure to set the static
correction on the Receiver Collar back to level 1 Tone Only.
Step
8
Summary of Contents for In-Ground Fence ZIG00-14654
Page 31: ...petsafe com 31 Layout Grid ...
