www.petsafe.net
21
To Cross Hard Surfaces
(driveways, sidewalks, etc.)
Follow all safety instructions for your power tools. Be sure to
always wear your safety goggles.
• Concrete Driveway or
Sidewalk (7C):
Place
the Boundary Wire in a
convenient expansion
joint
or create a groove
using a circular saw and
masonry blade. Place
the Boundary Wire in
the groove and cover
with an appropriate
waterproofing
compound. For best
results, brush away dirt
or other debris before
patching.
7C
7D
• Gravel or Dirt Driveway (7D):
Place the Boundary Wire in a PVC pipe or
water hose to protect the Boundary Wire before burying.
Place the Boundary Flags
The Boundary Flags are visual reminders for your pet of where the Warning
Zone is located.
1. Place the Test Light
contacts on the
contact points and
hold the Receiver
Collar at your pet’s
neck height.
2. Walk towards the
Warning Zone until
the Receiver Collar
beeps (
8A
).
3. Place a Boundary Flag
in the ground (
8B
).
4. Walk back into the
Boundary
Wire
8A
8B
Pet Area until the beeping stops.
5. Repeat this process around the Warning Zone until it is marked with
Boundary Flags every 10 feet.
Note: If you cannot hear the beep, see the Test Light Instructions in Step 6.
To prevent an unintended corection, after the Boundary Flags have
been placed, be sure to set the static correction on the Receiver
Collar back to level 1 Tone Only.
Step
8
Summary of Contents for IN-GROUND FENCE PIG00-10773
Page 35: ...www petsafe net 35 ...
