Enter the number of the milling cutter to be used (from 1 to 9 ).
ATTENTION
The machine can control a maximum of 9 milling cutter packs, while on the milling
cutter holding shaft can be mounted only 4 groups at the same time.
The controller memorises which milling cutter packs are mounted at every moment
on the machine and asks the operator to mount a different milling cutter should it
be necessary.
Repeat the same acquisition cycle from point 1 to point 5 for all profiles to be processed
adjusting the limit switch sensors.
In case of a wrong acquisition cycle, it is possible to cancel it from the memory.
6.4.1 Modification of the data for the automatic recognition
To modify the data acquired from the previously described programming procedure or to cancel
them act as follows:
1) From the main menu enter the key supplied in the programming key selector switch
(DWG. A1.18)
and turn the selector.
2) Press F1
The display shows:
MANUALE D’ISTRUZIONE PER L’USO E LA
MANUTENZIONE PULITRICE AUTOMATICA CM4S
37
File: 2240.doc - 03/11/03 14:27
