5.2 - THERMOSTAT INSTALLATION
•Disconnect the power supply from the device
•Fasten the base of the thermostat to the recessed box
(or to the wall) via the paired holes (fig. 5):
A-A
for a round box (60 mm diameter) with clips
B-B
for a round or square box with screws
C-C
for a rectangular box (3 places) with screws
•Implement the electrical connections as shown in the relative paragraph,
whilst paying particular attention when mounting on a wall without a
recessed box as the wiring must be placed properly for it to not interfere
when the body is closed.
•Apply the thermostat body to the base as shown in fig. 6.
•Press slightly until you hear the fastening teeth click into place.
•To remove the thermostat from the base, use a small screwdriver
to lever the fastening teeth (fig. 7).
N.B.
D
: fig.5, " ” = removable areas for wires to be inserted (only flexible ones)
A
B
A B
C
B
B
D
D
D
D
120
80
Fig. 5
Fig. 6
18
Fastening teeth
Fig. 7
5 - INSTALLATION
EN
30
