5
ROHO nexus SPIRIT Cushion Operation Manual
For additional assistance, contact your equipment provider, distributor, or Customer Support.
Not Holding Air -
Inspect for inflation valve and hose damage. Confirm that the inflation valve(s)
are completely closed. Look for holes in the cushion. If very small holes or no holes are visible, follow
the instructions in the Repair Kit provided with your product. For inflation valve or hose damage, or
for large holes or leaks in the cushion, see the Limited Warranty supplement, or contact Customer
Support.
Not Able To Inflate or Deflate the Cushion -
Confirm that the inflation valve(s) are open. Inspect
the inflation valve(s) and hose(s) for damage.
Uncomfortable or Unstable -
Confirm that:
- the cushion insert is not underinflated or overinflated. (See "Cushion Adjustment.")
- the air cells and the top of the cover are facing up.
- the cushion is centered beneath the individual.
- the cushion is properly sized to the individual and the wheelchair.
Allow the individual at least one hour to adjust to the cushion.
The Cushion Slides on the Wheelchair -
Make sure the non-skid bottom of the cushion cover
is facing down. Use directional labels on the cushion and on the cover to orient the cushion.
When possible, use hook and loop fasteners to further secure the cushion to the wheelchair. Hook
fasteners are available upon request.
Storage: Clean and disinfect the product before storing. Open the inflation valve. Store the product
in a container that protects the product from moisture, contaminants and damage.
Disposal: The components of the products in this manual are associated with no known
environmental hazards when properly used and when disposed of in accordance with all local/
regional regulations. Incineration must be performed by a qualified, licensed waste management
facility.
Recycling: Contact a local recycling agency to determine recycling options for the product. For more
recycling information, contact Customer Support.
Storage, Disposal and Recycling
Cover Removal and Replacement
Cover Removal:
Unzip the cover. Open the valve flap. Push the valve through the opening so that it is
inside the cover. Remove the cover from the cushion.
Cover Replacement:
Unzip the cover. Insert the cushion into the cover, front edge first, with the
air cells facing up. Open the valve flap. Reach into the cover and push the inflation valve through
the opening beneath the valve flap. Close the valve flap and the zipper. If hook fastener strips were
removed prior to washing, replace the strips.
Limited Warranty Term: 24 months from the date the product was originally purchased, with the
exception of the cover, which has a 6-month limited warranty. See also the Limited Warranty supplement
provided with your product, or contact Customer Support.
Limited Warranty
Troubleshooting