• Output lead connections
not connected.
Troubleshooting - Electronic Ignition
Problem (Ignition)
SECTION I
No sparks appear at
any electrodes when
control knob turned to
; no noise can be
heard from spark
module.
Possible Cause
• Battery not installed
properly.
• Dead battery.
• Button assembly not
installed properly.
• Faulty spark module.
• Check battery orientation.
• Has battery been used
previously?
• Check to insure threads are
properly engaged. Button
should travel up and down
without binding.
• If no sparks are generated
with new battery and good wire
connections, module is faulty.
Preventio
• Install battery (make sure that “+” and “-”
connectors are oriented correctly, with “+” end up
and “-” end down.)
• Replace battery with new AAA-size alkaline battery.
• Unscrew button cap assembly and reinstall, making
sure threads are aligned and engaged fully.
• Replace spark module assembly.
SECTION II
No sparks appear at
any electrodes when
control knob turned to
; noise can be
heard from spark
module.
• Are output connections
on and tight?
• Remove and reconnect all output connections at
module and electrodes.
SECTION III
Sparks are present
but not at all
electrodes and/or not
at full strength
• Output lead connections
not connected.
• Electrical arc between
output wires and grill
frame.
• Weak battery.
• Electrodes are wet.
• Electrodes cracked or
Broken; “sparks at crack”
• Are output connections on
and tight?
• If possible, observe grill in
Dark location.Operate ignition
system and look for arcing
between output wires and grill
frame.
• All sparks present but weak
or at slow rate.
• Has moisture accumulated
on electrode and/or in burner
ports?
• Inspect electrodes for cracks.
• Remove and reconnect all output connections at
module and electrodes.
• If sparks are observed other than from burner(s),
wire insulation may be damaged. Replace wires.
• Replace battery with a new AAA-size alkaline
battery.
• Use paper towel to remove moisture.
• Replace cracked or broken electrodes.
30
Summary of Contents for 40522S0LB
Page 18: ...a c b d 17 a 1 Top screw d 1...
Page 26: ...11 25 G H I J H K L...
Page 47: ...a c b d 46 M4x10 Tornillos Qty 6 pcs a 1 d 1...
Page 55: ...11 54 G H I J H K L...