Perlick Residential Refrigeration, User Manual, Page: 8 / 50

www.bringperlickhome.com
8
ILLUSTRATION 4. THREE-DOOR ANTI-TIP LAYOUT.
24"
1 15/16"
23 9/16"
15/16"
15/16"
24 3/16" SS DOOR
24 5/8" WOOD DOOR
22 3/4"
20 7/8"
1 1/2"
7/16"
Ø.375
1/4" REF
INSTALLING
IMPORTANT NOTE:
If installing on a concrete
floor, concrete fasteners are required and not
included with the anti-tip kit.
CAUTION
ANY FINISHED FLOORING SHOULD BE
PROTECTED WITH APPROPRIATE
MATERIAL TO AVOID DAMAGE FROM
MOVING THE UNIT. IF FOR ANY REASON
THE UNIT HAS BEEN LAID ON ITS BACK OR
SIDES, YOU MUST ALLOW THE UNIT TO
STAND UPRIGHT FOR A MINIMUM OF 24
HOURS BEFORE CONNECTING POWER.
Re-install the doors by removing the upper pivot
pin completely, sliding the door onto the lower
pivot pin and re-installing the upper pivot pin and
fastening tightly. Before moving the unit, make
sure the door is secured to the cabinet (tape
may be required to hold the doors closed).
Plug the unit into the 15 amp grounded outlet
located in the cabinet installation opening. With
power applied to the appliance, check for
lighting and cooling before going any further.
Once you are satisfied the unit is operating
properly, turn off the power to the wall outlet at
the circuit breaker and proceed.
WARNING
SHUT OFF POWER TO THE WALL OUTLET
BEFORE INSTALLING INTO THE OPENING.
Check the surrounding cabinetry to ensure that
the front face and interior opening is level and
square. Check to ensure the entire floor where
the cabinet is to be installed is level. Check that
the countertop bottom front edge is level. If all
surfaces are level, measure from the floor to the
bottom of the front edge of the countertop.
Measure the rear of refrigerated cabinet from
floor to top of cabinet at back corners. Adjust
rear corner leveling legs to achieve identical
measurements as previously measured from
floor to bottom edge of countertop. Adjust legs
by turning counterclockwise to raise the unit and
clockwise to lower the unit, using an adjustable
wrench or pliers. Once measurements are
identical, and if the cabinet has additional
leveling legs on rear of cabinet, adjust to proper
height to support center of cabinet.
IMPORTANT NOTE: Leveling legs should not
be extend more than ¾” from bottom of the
cabinet.
IMPORTANT NOTE:
The floor under the Perlick
cabinet must be at the same level as the
surrounding finished floor.