ø3/8 in.(10mm)
2 3/4 in.(70mm)
Drill 6 pilot holes using a 3/8
in.(10mm)diameter drill bit. Make sure
the depth is not less than 2 3/4
in.(70mm). Never drill into the mortar
between blocks.
1/2 in.(13mm)
Socket Wrench
(Not included)
Use the hammer to knock anchors
[A3] into the wall. Be sure the
anchors [A3] are seated flush with
the concrete surface.
Install arm assembly/wall plate
using lag screws [A1], washers
[A2] and anchors [A3]. Tighten
the lag screws [A1] only until the
washers [A2] are pulled firmly
against the wall plate. DO NOT
over-tighten the lag screws [A1].
2A-1
2A-2
2A-3
2A-4
05
Position the wall plate template
[05] at your desired height, level
the wall plate template and mark
the pilot hole locations.
A1 A2
A2
01
You may need
assistance with this step.
09
