ø3/8 in.(10mm)
2 9/16 in.(65mm)
Drill 4 pilot holes using a 3/8 in.
(10mm)diameter drill bit. Make
sure the depth is not less than 2
9/16 in. (65mm). Never drill into
the mortar between blocks.
Use the hammer to knock anchors
[A3] into the wall. Be sure the
anchors [A3] are seated flush with
the concrete surface.
Install wall plate using lag screws [A1],
washers [A2] and anchors [A3].
Tighten the lag screws [A1] only until
the washers [A2] are pulled firmly
against the wall plate. DO NOT
over-tighten the lag screws [A1].
2A-1
2A-2
2A-3
2A-4
You may need assis-
tance with this step.
3/8in.(10mm)
Socket Wrench
(Not included)
01
Position wall plate [01] at your
desired height, level wall plate
[01] and mark the pilot hole
locations.
A1
A3
A2
01
02
03
04
05
06
07
08
09
