PSE Status ( PSE
1/2 )
This LED will signify the status of the PSE function. Using multi-color and blinking the unit will show
the following status for the PSE;
GREEN — Solid: The PSE has successfully detected a compliant PD and is applying power over
the UTP (for legacy pin out simply show active power when applied)
YELLOW — Solid: The PSE is not active. This means the PSE has been configured to provide
power, but the PD is :
Not connected
Has not detected a compliant PD and is not applying power
PSE has turned off power for Reset function
OFF — PSE function switch disabled
RED — Blinking: Error Conditions
Capacitance too High — 1 blink
Resistance too Low or short circuit — 2 blinks
Resistance too high or open circuit — 3 blinks
Switches - accessible through a side opening in the chassis
Auto-Negotiation
(802.3u)
Enabled (Default) - The media converter uses 802.3u Auto-negotiation on the 10/100/1000Base-T
interface. It is set to advertise full duplex, half duplex, pause and remote fault capabilities.
Disabled - The media converter sets the port according to the position of the speed and duplex
switches.
