Power Connector
2-Pin pluggable terminal block
Indicators
Power ( PWR )
This green LED is turned on when power is applied to the media converter. Otherwise it is off. The
LED will blink slowly when either fiber port is in Loopback test mode. The LED will blink quickly if
there is a hardware failure where the reason code can be identified through a combination of
FDF,LKF, FDC and PSE indicator LEDs
Fiber link on /
Receive activity
( LKF 1/2 )
This green LED is operational only when power is applied. The LED will blink along with
transmit/receive data on the fiber port
If a loss of link on the copper port results in a Link Passthrough condition to the fiber port, this LED
will blink at a rate of once every 2 seconds until the condition is cleared.
Copper link on /
Receive activity
( LKC 1/2 )
This green LED is operational only when power is applied. The LED will blink along with
transmit/receive data on the 10/100/1000 UTP port
If a loss of link on the copper port results in a Link Passthrough condition to the fiber port, this LED
will blink at a rate of once every 2 seconds until the condition is cleared.
Fiber Duplex
( FDF 1/2 )
This green LED is operational only when power is applied. The LED is on when the
10/100/1000Base-X link is operational in full duplex mode. The LED is off when in half duplex. If the
Auto-Neg switch is turned off, this LED will always be on
Copper Duplex
( FDC 1/2 )
This green LED is operational only when power is applied. The LED is on when the
10/100/1000Base-T link is operational in full duplex mode. The LED is off when in half duplex
100/1000
This multi-color LED is operational only when power is applied. The LED is green when the speed of
the copper ethernet port is running at 1000 Mbps. The LED is yellow when the speed of the copper
Ethernet port is running at 100 Mbps. The LED is off when in 10 Mbps.
