Perle 10/100/1000 Ethernet Media Converter
Installation Guide
4
Installation
The default DIP switch settings (all switches in the UP position)
will work for most installations.
These are the steps required to configure the Perle S1110
Ethernet media converter:
1. Insert SFP Module (SFP Model only)
2. Set the Auto-MDIX jumper setting (optional).
3. Set the DIP switch settings (optional).
4. Install and connect the fiber cable.
5. Install and connect the copper cable.
6. Power up the media converter.
Auto-MDIX Jumper Settings
Note: The factory settings for Auto-MDIX will work for most
installations, but in the rare case that you need to modify the
settings, the procedure is below.
To access the Auto-MDIX jumper settings, unscrew the four side
screws on the top case and remove the cover plate. Locate the
MDIX AUTO jumper set as detailed below. By covering or
strapping pins 1 and 2, the S-1110 will operate as an MDIX
device. By covering or strapping pins 2 and 3, the S-1110 will
automatically detect the Ethernet cable’s polarity. Removing the
strapping is the same as AUTO.
NOTE: The default jumper setting is AUTO
