13
(4) In the pilot house, determine the desired location for the remote ammeter and the electrical con-
trol panel.
(5) Cut a 2 inch by 3 inch opening in the pilot house console for the electrical remote control panel.
A minimum of 3 inches clearance is needed behind the console opening.
(6) Using the remote control panel face plate as a template, drill four mounting holes, one in each
corner.
(7) Insert the remote control panel assembly into the console opening and secure it in place with
four screws through the face plate.
(8) The procedure for installing the remote ammeter is the same as the procedure for installing the
control panel, or it may remain in the bakelite case and placed on the console in an appropriate position.
NOTE
The remote ammeter is provided with a 30 ft. calibrated cable. Do not change the length
of this cable. Excess length should be coiled and stored under the console or near the Power
Supply.
(9) On top of the pilot house, install a weatherproof junction box (customer furnished) immediately
aft of the center of the searchlight base. With the searchlight components in place, the searchlight is now
ready for final interconnecting wiring as shown in Figure 2-1.
(10). Prepare and install a cable assembly from the Power Supply terminal block TB1 to the water-
proof junction box consisting of 2 conductors of No. 8 AWG and 7 conductors of No. 16 AWG (50 ft. maxi-
mum Length).
(11). Prepare and install a cable assembly from the Power Supply terminal block TB2 to the pigtail
leads attached to the control panel, consisting of 6 conductors of No. 16 AWG.
2-4
POST-INSTALLATION AND CHECKOUT.
After the equipment is installed and all electrical inter-
connections are made, perform the following inspection and checkout procedures:
(1)
Check for loose parts, connections and misplaced tools.
(2)
Check for proper routing and interconnection of cables.
(3)
Check that all equipment is properly secured and adjusted.
Summary of Contents for 9304
Page 2: ......