SEBU8337
69
Maintenance Section
Engine Oil and Filter - Change
g01394084
Illustration 36
4.
Install the
fi
lter element into the
fi
lter bowl. Ensure
that the insert (3) on the oil
fi
lter aligns to the
square (4) in the
fi
lter bowl.
g01394093
Illustration 37
Typical example
NOTICE
Do not
fi
ll the oil
fi
lters with oil before installing them.
This oil would not be
fi
ltered and could be contaminat-
ed. Contaminated oil can cause accelerated wear to
engine components.
5.
Install the O ring seal (5). Lubricate the threads on
the
fi
lter bowl with
CV60889
Special Lubricant.
6.
Install the
fi
lter bowl and the element. Tighten the
fi
lter bowl (1) to a torque of 90 N·m (66 lb ft).
7.
Install the drain plug (2) and tighten to 1.2 N·m
(11 lb in).
Fill the Engine Crankcase
1.
Remove the oil
fi
ller cap. Re
fi
ll the engine
crankcase with engine oil. Refer to the Operation
and Maintenance Manual, “Re
fi
ll Capacities ”
and Operation and Maintenance Manual, “Fluid
recommendations” for more information.
NOTICE
If equipped with an auxiliary oil
fi
lter system or a re-
mote oil
fi
lter system, follow the OEM or
fi
lter manu-
facturer’s recommendations. Under
fi
lling or over
fi
lling
the crankcase with oil can cause engine damage.
NOTICE
To prevent crankshaft bearing damage, crank the en-
gine with the fuel OFF. This will
fi
ll the oil
fi
lters before
starting the engine. Do not crank the engine for more
than 30 seconds.
2.
Start the engine and run the engine for two
minutes. Perform this procedure in order to ensure
that the lubrication system has oil and that the oil
fi
lters are
fi
lled. Inspect the oil
fi
lter for oil leaks.
3.
Stop the engine and allow the oil to drain back to
the sump for a minimum of ten minutes.
4.
Remove the oil level gauge in order to check the
oil level. Maintain the oil level between the “Low”
and “High” marks on the oil level gauge.
