12
11. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your
satisfaction. This warranty applies only to the original purchaser of this prod-
uct from an authorized Peripheral Electronics dealer. This warranty covers
any supplied or manufactured parts of this product that, upon inspection by
Peripheral Electronics authorized personnel, is found to have failed in normal
use due to defects in material or workmanship. This warranty does not apply
to installation expenses. Attempting to service or modify this unit, operating
this unit under conditions other than the recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, Peripheral Electronics shall not be liable for
any personal injury, property damage and or any incidental or consequential dam-
ages of any kind (including water damage) resulting from malfunctions, defects,
misuse, improper installation or alteration of this product. All parts of this Peripheral
Electronics product are guaranteed for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above,
Peripheral Electronics will repair or replace the product at their discretion, if it
is defective in material or workmanship providing it is returned to an Authorized
Peripheral Electronic’s dealer, with PROOF OF PURCHASE from an authorized
Peripheral Electronics dealer.
Warning
:
This equipment may be reset by unintentional electrostatic discharge during
operation. Exposure to direct sunlight or extreme heat may cause damage or
malfunction.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit differant from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical
for help.
Notice : The changes or modifications not expressly approved by the party responsible
for compliance could void the user authority to operate the equipment.
For Best Performance Have It
Professionally Installed.
Summary of Contents for iSimple PGHGM4
Page 15: ...13 NOTES ...
