Fastening Posts To Concrete
Deck Application
Patio Paver Application
5
/
pergolakitsusa
com
Using a hammer drill with a 3/8"
concrete bit, drill holes 1/2"deeper
than the length of the type (J) lag.
WARNING!
Concrete Footer
Patio Pavers
Fasten Posts to concrete slab useing type
(J) concrete lags.
Type (J) Concrete Lag
3/8" X 3" x 4 per post.
Note: Be Sure to plum
all of the posts.
Type I Lag
Be sure to pre drill holes for the type (I) wood lags
Deck Board
Vinyl Post Sleeve
Post Trim
Post Insert
Support Block
Floor Joist
3/8" Masonary
Drill Bit
If your posts are not located so you can attach them to
a floor joist, follow the below instructions.
Make a support block by cutting a generic treated board
(not included) into 6 pieces that are the same length as the
spacing inbetween the floor joists of your deck.
Fasten the 6 pieces together using 2 1/2" deck screws (not
included). You will need to make four blocks like this.
Fasten a support block inbetween the floor joists at the
location of each pergola post. Push the block up against the
deck boards and and attach it by driving 3 1/2" deck screws
(not included) through the sides of the floor joists and into
the support block.
Now attach your pergola posts to the deck as
shown in the example above. The lags (type I)
should go through the deck boards and into
the support blocks.
Concrete Slab
If installing on a paver
patio, pavers should be
removed at each post location.
Dig holes 3 ft in depth or
recommended hole depth
your local building codes.
Fill holes with concrete to
createa solid footer for posts.
After concrete footers are
completely cured, attach
posts using the
same method
shown at the
top of this page.
Do not mount
posts directly onto
patio pavers.
(PAVERS ARE NOT STABLE)
Patio Pavers
Support Block
Ste
p 4