3 of 6
Step 1 - Back Assembly
Place the left and right hand backs on a level surface (flange sides facing up; Figure 1). Use packing material to
protect the finish. Place the panel with the center tabs (left hand back) under the panel with the center rectangular
holes (right hand back). Make sure the tabs ride into the rectangular holes and slide the backs together. Check to
make certain that all the tabs and rectangular holes have engaged completely and that the screw holes on the
back panel have properly aligned. Use a small tipped screwdriver to assist in aligning the screw holes if necessary.
Figure 1
– Back Assembly
Figure 2- Side Assembly
Step 2 - Side Assembly
Identify the right side panel and the left side panel by taking one of the panels and place the tabs facing up. Use a
small blade screwdriver to push tabs out slightly. Place the corresponding side panel under the back assembly
making sure the tabs of the side panel ride into the rectangular holes of the back assembly. Slide the parts together
making sure that the tabs and rectangular holes fully engage (properly completed, the side and back assembly will
be even at both ends). After assuring the correct side is fastened to the back assembly and the tab engagements
are complete, tap tabs down with a rubber mallet to tighten the engagement. Repeat the same process for the
opposite side panel. Finish attaching sides to back panel by using two M6*10 bolts and M6 nuts, these are located
at the bottom (ref Fig 2).
Step 3
– Bottom Assembly
Use a small blade screwdriver to push tabs out slightly. Holding the bottom from the large side (front), place the
bottom onto the inside of the back and side assembly. The rear part of the bottom will slide down onto four (4) tabs
located on the back assembly. Once all tabs have been properly engaged, move the front of the bottom into
position so that the two (2) screw holes align with the left and right side panel (use a small tipped screw driver to
assist in aligning the holes if necessary). Using two M6*10 bolts and M6 nuts, attach the bottom to the sides. Also
use one screw and nut to fasten the bottom to the back assembly. (See figure 3 Bottom assembly).
