BATTERY PACK INSTALLATION
TO REMOVE BATTERY PACK:
1. Press release button on front side of the
Cordless Drill to release the battery pack.
2. Pull battery pack free of Cordless Drill.
TO ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack
with the groove in the battery compartment
of the Cordless Drill.
2. Press the battery pack into place. Make sure
the latch is securely fastened. Do not use
the Cordless Drill if the battery pack is not
seated properly.
BATTERY PACK CHARGING OPERATIONS
NOTICE
The charger will not automatically
turn “OFF” when the battery pack is fully
charged. The charging indicator light will
remain “ON” until the charger is disconnected
from the electrical outlet. Remove battery
pack from charger and disconnect charger
from power after 5 hours of charging
operation Overcharging can overheat battery
cells and cause permanent damage to the
battery pack and charger kit.
1. Make sure the trigger on the Cordless Drill is
in the “OFF” position and remove the battery
pack from the Cordless Drill.
2. Plug 120V AC Adapter into household outlet
and into side of battery charger. The Red
indicator light will come “ON”.
3. Insert battery pack into battery charger. The
Green indicator light will come “ON” indicat-
ing that battery is being charged.
4. After 3 - 5 hours of charging, remove the
battery pack from charger and reattach bat-
tery pack onto Cordless Drill, making certain
latches fasten securely. Cordless Drill will
not operate properly if the battery pack is not
seated properly.
NOTICE
Continuous use of your tool causes
the battery pack to become hot. Let a hot
battery pack cool down for approximately 30
minutes before attempting to recharge.
BATTERY PACK USAGE AND CHARGING OPERATIONS
Figure 1
Battery Pack
Battery Charger
120V AC Adapter
