Perfelli DNS 6723 B 1100 LED Strip, User Manual

Page: 27 / 32

Pic. 12
Hoods DNS 6723 B 1100 LED Strip, DNS 9723 B 1100 LED Strip is equipped with a
sensor control with display (Pic. 12).
- Turns on and off the engine. The engine initially starts from the second speed.
- Decreases the engine speed down to the 1st speed. The speed levels go down
successively as the button is pressed down. The speed levels go down one by one as the
button is pushed and released.
- Increases the engine speed up to the highest. The speed levels go up successively
as the button is pressed down. The speed levels go up one by one as the button is pushed
and released.
- When the timer button is pressed as the engine is running, the number of the current
speed starts to blink on the screen. Following a blinking period of 15 minutes the engine
and the lights – if open – will go off. If the timer button is pressed once again, the blinking
stops and the timer gets cancelled.
-Turns on/off the lights.
When the engine reaches and running time of 60 hours, “C” (filter full) symbol will appear
on the screen. After cleaning the filter; press the M. on/off button until the symbol “E”
appears on the screen and that way the filter timer gets reset.
- Use the pipes with 120-150 mm diameter.
- Install the flexible aluminum pipe on the outlet of the cooker hood. Install the other end of
the pipe to the chimney hole on the wall (Pic. 10).
Since the bends and elbows will cause reduction in air excessive and bents must be avoided
elbows as much as possible (Pic. 11).
4.4 INSTALLING THE ALUMINUM PIPE
5. CONTROL PANEL
Pic. 10 Pic. 11