![background image](http://html1.mh-extra.com/html/perel/whw420/whw420_user-manual_1528861010.webp)
WHW420
V. 01 – 11/04/2014
10
©Velleman nv
Detaching a Cable
Warning!
Be very careful when you detach an old cable. The cable
clamp holds the cable under tension, and the cable may spring
back forcefully.
To detach an old cable, proceed as follows:
1.
Detach any load from the cable.
2.
Place the pawl
[2]
in the reel-out position
[c]
.
3.
Turn the handle counter-clockwise to reel out the entire cable.
4.
Loosen the clamp nut and remove the cable from under the clamp.
5.
Inspect all parts of the drum and clamp before installing a new cable.
8.
Operation
8.1
Precautions
Warning! Read all instructions carefully. Failure to follow
the instructions may result in serious damage and severe
injury.
Warning!
To prevent serious injury from winch failure, do not use
damaged equipment. If you observe any abnormal noise or vibration, stop
using the device immediately and have it serviced by a qualified technician.
Before use, make sure that the load is within the rated capacity.
If any part of the winch starts to bend, deform, or show any signs of
damage, stop using the winch immediately.
Warning!
Do not let go of the handle when the pawl is in the unlocked
position while there is a load on the winch. The handle can spin violently
and cause serious injury. Never try to stop a spinning handle.
Never unwind the line fully when pulling a
load.
Always keep 4 to 6 complete turns of line
around the drum; otherwise, the line may come
loose from the drum.
8.2
Winching
To winch a load, proceed as follows:
1.
Before connecting the line to the load, make sure that the winch and
line are capable of pulling the load.
2.
Place the pawl
[2]
in the reel-out position
[c]
.