![background image](http://html1.mh-extra.com/html/perel/whw420/whw420_user-manual_1528861009.webp)
WHW420
V. 01 – 11/04/2014
9
©Velleman nv
3.
Thread the rope through the round holes in the drum’s side. There are
two methods, depending on the weight of the line. See the illustration
below for instructions.
heavy line
light line
4.
Place the pawl
[2]
in the reel-in position
[a]
.
5.
Turn the handle clockwise to reel in the rope. Pack the coils tightly side
by side, so that the next layers cannot slip between the coils.
6.
When you have reeled in the rope, attach the hook to the shaft
[3]
to
prevent that the rope unwinds.
7.2
Cable
Attaching a Cable
Attaching cable requires a cable clamp
(not incl.). To attach a cable to the
winch drum, proceed as follows:
1.
Place the pawl
[2]
in the free-
spooling position
[b]
so that it is
disengaged from the gear and the
drum can rotate freely.
2.
Attach the clamp with the bolt
through the square hole in the
drum’s side. The bolt goes on the
inside, the locking nut and washer
on the outside. Do not tighten the
nut yet.
3.
Guide the cable end under the hub of the drum
[4]
.
4.
Thread the cable through a round hole in the drum's side.
5.
Thread the cable further through the clamp and make sure that the
end protrudes about 1" (2.5 cm).
6.
Tighten the nut firmly.
7.
Place the pawl
[2]
in the reel-in position
[a]
.
8.
Turn the handle clockwise to reel in the cable. Pack the coils tightly
side by side, so that the next layers cannot slip between the coils.
Warning!
Prevent kinks in the cable.
9.
When you have reeled in the cable, attach the hook to the shaft
[3]
to
prevent that the cable unwinds.