WHW250
V. 01 – 11/04/2014
9
©Velleman nv
heavy line
light line
4.
Push the pawl
[2]
up so that it engages with the gear.
5.
Turn the handle clockwise to reel in the rope. Pack the coils tightly side
by side, so that the next layers cannot slip between the coils.
6.
When you have reeled in the rope, attach the hook to the shaft
[3]
to
prevent that the rope unwinds.
7.2
Cable
Attaching a Cable
Attaching cable requires a cable clamp
(not incl.). To attach a cable to the
winch drum, proceed as follows:
1.
Push the pawl
[2]
down so that it
is disengaged from the gear and
the drum can rotate freely.
2.
Attach the clamp with the bolt
through the square hole in the
drum’s side. The bolt goes on the
inside, the locking nut and washer
on the outside. Do not tighten the
nut yet.
3.
Guide the cable end under the hub of the drum
[4]
.
4.
Thread the cable through a round hole in the drum's side.
5.
Thread the cable further through the clamp and make sure that the
end protrudes about 1" (2.5 cm).
6.
Tighten the nut firmly.
7.
Push the pawl
[2]
up so that it engages with the gear.
8.
Turn the handle clockwise to reel in the cable. Pack the coils tightly
side by side, so that the next layers cannot slip between the coils.
Warning!
Prevent kinks in the cable.
9.
When you have reeled in the cable, attach the hook to the shaft
[3]
to
prevent that the cable unwinds.
Detaching a Cable
Warning!
Be very careful when you detach an old cable. The cable
clamp holds the cable under tension, and the cable may spring
back forcefully.
