Perel SCAMSETW2, User Manual

Page: 4 / 15

SCAMSETW2 PEREL 4
5. Description Receiver
1. power switch
2. antenna socket
3. power socket
4. A/V output
5. antenna
6. channel button
7. channel indicator
6. Installation
1. Put the camera in the desired location and then adjust the angle.
2. Connect the adapter (DC 8V 200mA) to the camera.
3. Connect the antenna to the receiver.
4. Connect the adapter (DC 8V 200mA) to the receiver. Slide the power switch to the ON position.
5. Connect the receiver to a monitor/TV with the A/V cable (yellow for video and red for audio).
6. Switch on the monitor/TV and select A/V mode.
7. Use the channel button to s et the same channel on the receiver as on the camera .The camera picture is now
displayed on the monitor/TV.
8. Adjust the brightness, contrast and colour of the monitor/TV.
7. Camera Channel Set-up
Remove the camera cover and reach for the DIP switches next to the lens. Choose a channel by setting the DIP
switches. Replace the camera cover. Use the SEL button to select the same channel for the receiver as for the
camera. The image is now displayed on the TV.
8. General Guidelines
•
Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
•
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source
9. Specifications
Operating temperature 0 to +50°C/ +32 to +122°F
Storage temperature -30 to +80°C/ -22 to +176°F
Operating humidity 85% RH
Camera (order code SCAMW2, also compatible with SCAMW3, SCAMW4)
Imaging sensor CMOS
Total pixels 628 x 582 (PAL); 510 x 492 (NTSC)
Viewing angle 62°
Transmission frequency 2.400 to 2.483MHz
Transmission power 10mW/CE; 2mW/FCC
Modulation type FM
Bandwidth 18MHz
Power supply 8V DC
Current Consumption 80mA & 120mA (IR ON)
Effective range (line of sight) 100m
Dimensions (W x D x H) Ø 44 x 56mm (without bracket)
Weight 220g