SCAMSET6
2
PEREL
Monitor unit
1. image impedance switch
2. handset
3. 4" b/w monitor
4. volume control
5. brightness control
6. contrast control
7. "unlock" LED
8. monitor button
9. intercom button
10. unlock button
11. power LED
1. First install the cable. To connect the camera and monitor units, a 75ohm 5C2V coax cable is recommended.
2. Push the camera unit's screw cover (fig.1 #4) upwards and
remove the (hex) screw under it. Flip the camera unit
away from the rain cover. Now you can also remove the
bottom screw if you want to separate them completely.
Pull the wire through the hole in the rain cover and mount
the rain cover to the wall (see fig. 3). Connect the wire to
the camera unit, flip the camera unit up (or fasten the
bottom screw and flip it up) and fasten it with the top screw. Pull the screw cover down (fig.1 #4).
3. For the monitor unit: pull the wire through the hole in the mounting
bracket and mount the bracket to the wall. Connect the wire to the
monitor unit. Put the monitor unit on the 4 pins on the bracket (fig.4 #1)
and fasten it by means of a screw on either side of the unit (fig.4 #2). Set
the impedance switch of the monitor unit (fig.2 #1) to "75 ".
4. It is possible to connect up to three monitor units to one camera unit,
providing that the total cable length does not exceed 100m. Additional
monitor units are available separately (order code
SCAMSET6-M
).
Connect the monitor units as in the figure below. The image impedance
switch (fig.2 #1) of the last unit must be set to "75 ", the others to "OFF".
5. It is also possible to connect an electronic door lock to the monitor unit. This can be done by means of the 2-pin
connector (L+ and L-) at the back of the monitor unit. We recommend that no more than 2 monitor units be
connected to an electronic lock (max. cable length 25m).
4. Operation
•
When the call button (fig.1 #7) is pressed, the monitor unit emits a chime sound and the visitor's image appears.
•
Pick up the handset to communicate with the visitor. Put it down to end the communication - the monitor will be
switched off simultaneously.
•
If there is no communication (handset is not picked up), the monitor will automatically switch off after 30 seconds.
•
If you want to let the visitor in and an electronic door lock is installed, press the unlock button (fig.2 #10).
•
Communication can also be established from inside: pick up the handset and press the 'monitor' button (fig.2 #8).
•
Verify if anyone is at the door by pressing the monitor button without picking up the handset. To switch the monitor
off again, pick up the handset and put it back, or let the monitor auto switch off after 30 seconds.
•
If more than 1 monitor unit is installed, the intercom button (fig.2 #9) can be used to call another monitor unit.
Fig.2
Fig.3
Fig.4
Fig.5
