![background image](http://html1.mh-extra.com/html/perel/leds10drgb/leds10drgb_user-manual_1528603007.webp)
LEDS10DRGB
V. 03 – 22/11/2017
7
©Velleman nv
2.
Connect the LED strips to the controller (see
[A2]
). Make sure
to connect matching wire colours and do not short-circuit any
wires. Connecting tools are not included.
3.
Connect the included power adapter to the controller (see
[A3]
).
4.
Plug the adapter into the mains. Refer to illustration
[A4]
for a
general connection scheme.
7.
Remote Control
Battery
Refer to illustration
[B1]
on page 3 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025
(included). Remove the tag from the battery compartment before
use.
1.
To (re)place a battery, press on the side of the battery cover
and pull to slide open.
2.
Insert the battery with the correct polarity and close the battery
compartment by pushing back into the housing of the remote
control until it snaps into place.
Operation
1.
Aim the remote control towards the IR LED of the controller to
control the output of the LED strip.
2.
Switch on the LED strip with the ON button on the remote
control. To switch it off again, press the OFF button.
3.
Refer to chapter
5. Overview
for more information about
operating the remote control.
8.
Technical Specifications
IP rating
IP61
coating
silicone
colour
red/green/blue
wavelength
red
green
blue
615-630 nm
520-530 nm
465-470 nm
IC type
TM1804
viewing angle
120°
LED spacing
33 mm
power supply
12 VDC 24 W (adapter incl.)