TTD-08A Electromechanical Box Tripod Turnstile
33
7. Fix the bracket with control board and remote connector block in an order, opposite
to removal.
8. Check reliability of the cable connections to the CLB connector blocks and if
necessary tighten the cable fixing screws.
9. Check reliability of the barrier arm (5) fastening.
10. Remove side panels (6, 7), assembled with top covers (8, 9) in an order (ref.
Section 8.5. Check reliability of the turnstile housing fastening to the floor and if
necessary, tighten the anchor bolts.
11. Put back side panels (6, 7), assembled with top covers (8, 9) in an order, opposite
to removal.
12. Return the top cover (3) into its operating position.
13. Energize the turnstile and lift up the folding arm.
14. Check operation of the turnstile in accordance with Section 9 of this Manual.
After maintenance works are complete the turnstile is ready for further operation.
In case of any defects revealed during visual check please apply to the PERCo
Technical Support Department (the PERCo TSD).
11 TRANSPORTATION AND STORAGE
The turnstile in the original package should be transported in closed freight containers
or other closed type cargo transport units.
During storage and transportation the boxes with the turnstiles can be stacked
maximum 2 layers high.
Storage of the turnstile is allowed in dry indoor facilities at an ambient air temperature
from –40°C to +55°C at relative air humidity 98% at +25°C.
After transportation or storage at temperatures below zero or at high air humidity, prior
to installation the turnstile must be kept in the original package for no less than
24 hours
indoors under conditions corresponding to operation conditions
(Ref. Section 2).
Summary of Contents for TTD-08A
Page 1: ......
Page 38: ...www perco com export perco ru ...
