Assembly & Operation Manual
26
8.5 Installation procedure
Attention!
The manufacturer shall not be liable for any damage caused as the result of
improper installation and declines any claims arising thereof in case if the
installation is done not in compliance with the instructions provided in this
Manual.
Content of installation procedures is presented per feedback in sec 8.1. Equipments and
tools, required for installation, are listed in sec. 8.2. Cable types, used during installation,
are listed in sec. 8.3. Connection layouts of the turnstile and optional equipment are
presented in sec. 8.4. Item numbers are listed in accordance to Fig. 2.
Figure 14 – TTD-08A turnstile housing installation layout
During turnstile installation keep to the following procedure:
1. Unpack the turnstile and check the completeness as per Section 4 of the product
certificate.
2. Install the turnstile power supply unit in its place (See power supply unit certificate
for installation procedure of the power supply unit).
3. Drill the holes for anchor bolt sleeves to fix the turnstile housing (Ref. Fig. 14.
4. If you lay the cables under the floor surface, prepare the electric raceway to the
cables laying zone of the turnstile housing. The cables layout inside the turnstile
housing is shown in Fig. 12.
Caution!
•
It is necessary to leave a reserve of length, enough for hinged joint removal and
for the access to the barrier arms rotation unit, of those cables that are
connected to the remote connector block and control board.
•
Fix the housing after laying the cables in the electric raceway and inside the
turnstile housing. Be careful and prevent the turnstile from falling before it is
fixed.
1. Insert the sleeves for the anchor bolts into the holes so that they do not stick out
above the floor surface.
2. Remove the turnstile housing top cover (3) (Ref. Section 6.
5. Remove the turnstile housing side cover (7), assembled with a top cover (9). For
this purpose:
•
Loosen two screws (2 in Fig. 15).
•
Remove the wall from the housing and disconnect the cable, connecting
indication plates (8 on Fig. 12) from indication plate 2, located under the cover.
•
Remove the back panel and accurately put it on the straight stable surface.
Summary of Contents for TTD-08A
Page 1: ......
Page 38: ...www perco com export perco ru ...
