Certificate & Installation Manual
2
4 INSTALLATION ORDER
Attention!
ST-11
speed gate installation order
– see in
ST-11 Assembly and operation manual
. It must
be considered that overall length of a speed gate section with an installed
FP-11Q.1
panel
increases for 110 mm (see Fig.1).
Figure 1. ST-11 section with installed FP-11Q.1 front panel
FP-11Q.1
front panel is to be installed on
ST-11
speed gate instead of a standard front panel of the
section (see Fig. 1). Layout of
FP-11Q.1
front panel is shown on Fig. 2. Hereinafter item numbers
are indicated according to Fig. 2.
1. Dismantle the top cover, stainless or made of artificial stone, from the
ST-11
section. To do this,
use a SW4 hex wrench to unscrew four screws through the holes in the lower part of the top box
of the section (see
ST-11 Operation Manual
, section 8.8.6). At the stone cover, disconnect the
indicator cable from the indication plate.
2. Remove the front panel from the turnstile section (see
ST-11 Operation Manual
, section 8.8.2),
to do this, press it down to the stop and pull the upper part towards you, removing the panel hooks
from the grooves.
3. Remove the indication plate from the front panel by unscrewing 4 screws securing it to the bracket
inside the front panel. Fix the indication plate inside the upper box under the
ST-11
section top
cover on 4 self-adhesive PCB pillars from the
FP-11Q.1
panel delivery set. Connect the CAN
connecting cable to the indication plate (see Fig. 2).
4. Unpack the
FP-11Q.1
panel. Open the lock (5) of the front cover of the panel (4) using the supplied
key and remove it. If needed install an ACS controller.
Attention!
ACS controller is not included in a delivery set. Maximum dimensions of a built-in ACS
controller should be not more than 250
×125×70 mm (L×W ×H).
Controller should be installed on a bracket (6). To install a frameless controller delivery set includes
self-adhesive PCB pillars. Removable bracket should be installed with two screws (7).
5. Install the
FP-11Q.1
panel into place in the
ST-11
speed gate. With a marker, through two holes
at the bottom of the panel base, mark on the mounting surface the fixation points of the panel.
