FP-01C
Front panel for ST-01 Speed gate
11
13. Click
"Edit"
button on the page toolbar. The
"Device properties"
window will be
opened.
14. Switch to
"Reader No... "
tab (number of the reader must match the reader, which is
controlled by the card capture reader).
15.
The “Card captured” signal sent by the card capture reader is considered as a confirmation of
withdrawal of the card. To configure the confirmation parameters, select the group of
"Verification"
parameters and set the following values:
•
for
"Verification"
parameter:
-
set
"External verification device"
value, if the card reader acts as an external
verification device for a controller ("Card captured" signal is sent to a separate input of
the controller),
-
set
"Remote control"
value,
if the “Card captured” output of the card capture reader
is connected to the controller in parallel with the RC. In this case, it is also necessary
to check
"In “Control” mode"
box on the left side of the
"Remote control
permission"
window:
•
Check boxes of the
"Verify VISITORS IDs from the
external verification devices"
parameter (or, respectively,
"…from the
remote control"
):
-
"When passing"
;
-
"When passing with VIOLATED TIMING"
;
-
"When passing with ZONALITY VIOLATION"
.
•
specify the desired value for the
"Waiting period for verification confirmation from the
external verification device"
parameter (or, respectively,
"…from the
remote control"
)
which will be used by the controller for waiting of a "Card captured" signal.
16. In the left part of the working area tab select
“
Additional outputs activated upon VISITORS
valid identifiers
”
parameter and set:
•
set
"For the operation time"
value for the
"Activation criteria"
parameter by using the
drop-down list.
•
in the pop-up list of additional outputs check
"Additional output
No.3"
(number of the
output that is connected to the "
Capture card
" input of the card capture reader).
Summary of Contents for FP-01C
Page 21: ......
