Pepperl+Fuchs ODT-MAC40-RD Series, Manual, Page: 24 / 37

2
012-
10
24
ODT-MAC40*-*-RD
Operation
System Settings
Sending a command
You have the option of sending individual commands to the sensor. The
commands are made up of 4-digit hexadecimal numbers (0 ... F). An overview of
the available commands can be found in the appendix.
1. If you are not already on the
Settings tab, navigate to it.
2. Enter a valid, 4-digit hexadecimal number for the required command in the
Command field.
3. Click on Send .
The relevant command will be sent to the sensor, where it will be
executed.
Setting Explanation
Parameter set Load from flash: Use this action to load parameter settings from the internal
memory bank (flash EEPROM).
Save to flash: Use this action to save your current parameter settings in the
internal memory bank (flash EEPROM).
Command Send individual commands to the reader
Trigger signal edge Use this parameter to set the trigger edge, at which the sensor is to be triggered.
Possible settings are the rising or falling edge.