Introduction
2
0
1
8
-1
2
5
1
Introduction
1.1
Content of this Document
This document contains information required to use the finished device or system in the
relevant phases of the product life cycle. This may include information on the following:
■
Product identification
■
Delivery, transport, and storage
■
Mounting and installation
■
Commissioning and operation
■
Maintenance and repair
■
Troubleshooting
■
Dismounting
■
Disposal
The documentation comprises the following parts:
■
This hardware manual
■
Software manual for the com units in use
■
Instruction manuals for the components in use
■
Datasheets for the components in use
In addition, the documentation may comprise the following parts, if applicable:
■
EC-type-examination certificate
■
EU declaration of conformity
■
Attestation of conformity
■
Certificates
■
Control drawings
■
Other documents
1.2
Target Group, Personnel
Responsibility for planning, assembly, commissioning, operation, maintenance, and
dismounting lies with the plant operator.
Only appropriately trained and qualified personnel may carry out mounting, installation,
commissioning, operation, maintenance, and dismounting of the product. The personnel must
have read and understood the instruction manual and the further documentation.
Ensure that you are familiar with the system and its components before use. Read the
documentation carefully.
Note!
This document does not replace the instruction manuals for the components in use.
The safety information for the components in use determines the specific safety instructions
that apply to the system. The instruction manuals for the components in use must have been
read and understood.
Note!
For complete information about the components in use, refer to the instruction manuals and
additional documentation available online at www.pepperl-fuchs.com.
