PePLink Balance Series v4.0 User Manual
Page 75
14
Configuration of NAT Mappings
This configuration replaces “DMZ” in firmware versions prior to 3.8. The configuration of
NAT Mappings allows the IP address mapping of all inbound and outbound NAT’ed traffic to
and from an internal client IP address.
The settings to configure NAT Mappings are located at
Network > NAT Mappings
:
To add a NAT Mapping, click
Add NAT Rule
, upon which the following screen is displayed:
NAT Mapping Settings
LAN Host
This is the IP address of the host on the LAN that the system should
map the selected connection IP address correspondences.
Inbound
Mappings
This setting specifies the WAN connections and corresponding WAN-
specific Internet IP addresses on which the system should bind on.
Any access to the specified WAN connection(s) and IP address(es) will
be forwarded to the LAN Host.
Note 1: Inbound Mapping is not needed for WAN connections in drop-
in or IP forwarding mode.
Note 2: Each WAN IP address can be associated to one NAT Mapping
only.
