Pentium Third Serial Port Installation
CTC Parker Automation
17
2. On the Settings submenu, press the PWRSTA button.
The PowerStation Settings menu will appear, as shown below.
3. On the PowerStation Settings submenu, press the Calibrate
Touchscreen button.
You will be prompted that a keyboard is needed to calibrate
the touchscreen. Then you will be asked if you want to
continue.
4. If necessary, install a keyboard on the PowerStation. See your
PowerStation User Manual for information about connecting
a keyboard to the PowerStation.
5. When you have attached a keyboard to the PowerStation,
press the Yes button to continue the calibration.
6. Press any key on the keyboard when you are ready to begin the
calibration program.
7. Type
H
for Hard calibrate.
8. When the next screen appears, follow the instructions on the
screen by touching each square as it appears until you hear a
beep.
9. When you have finished, press any key.
10. Press
X
or Esc
to exit the calibration utility.
Important
After calibrating the touchscreen, enter Interact in Program
Mode. Verify that the cursor appears on the screen where
you touch. If it does not, recalibrate the touchscreen. The
calibration must be accurate to avoid activating a button
unintentionally during Run Mode.
