Pentium Third Serial Port Installation
12
CTC Parker Automation
Install the Third COM Port (COM3)
After you have reinstalled the reconfigured System Support card,
you are ready to install the third COM port (COM3) on your
PowerStation.
To install the third COM port, complete the following steps:
1. Insert the new serial tang (from the Third COM Port Upgrade
Kit) into the next available slot, as shown in the illustration be-
low.
Note
You may need to remove a blank cover if an insertion slot
is not available for the new serial tang.
2. Attach the 9-pin ribbon cable from the new serial tang to the
System Support card, as shown in the preceding illustration.
Close the PowerStation
After you have established COM2 on the CPU card and installed
the reconfigured System Support card and the third COM port,
close the PowerStation.
In order to close the PowerStation, complete the following
steps:
1. If you have a CF card, insert it into the PowerStation’s flash
card slot.
Important
Make sure that the PowerStation is turned off when you
insert the CF card.
New serial tang
9-pin ribbon
cable
System Support
card
