GA-586IP
_____________________________________________________________
_____________________________________________________________18
the mainboard uses simulation method to implement TURBO switching function. The J12 on
mainboard should be connected to the TURBO switch on panel, and user can push in or pop
out the TURBO switch to enable or disable the turbo function of system.
M
If not necessary, please don't use De-turbo mode. (always keep system in Turbo
mode)
3.11. TURBO LED CONNECTOR INSTALLATION
The TURBO LED on panel can indicate the current speed status of system. The TURBO LED
connector should be installed to J13 in correct direction.
3.12. HARDWARE RESET SWITCH CONNECTOR INSTALLATION
The RESET switch on panel provides users with HARDWARE RESET function which is
almost the same as power-on/off. The system will do a cold start after the RESET switch
is pushed and released by user. The RESET switch is a 2 PIN connector and should be
installed to J8 on mainboard.
3.13. PERIPHERAL DEVICE INSTALLATION
After the device installation and jumpers setup, the mainboard can be mounted into the case
and fixed by screw. To complete the mainboard installation, the peripheral device could be
installed now. The basic system needs a display interface card and a disk control interface
card.
If the PCI - Bus device is to be installed in the system, any one of three PCI - Bus slots can
be used no matter Slave or Master PCI - Bus device being installed.
After installing the peripheral device, the user should check everything again, and prepare to
power-on the system.
