4
ThermalFlo Addendum
6. AutoSet
– Certain heat pump models have the ability to start and stop a remote water pump.
This AutoSet feature, if enabled, allows the heat pump to periodically energize the filter pump and
test the temperature of the water in the pool or spa. If the water requires heating, or cooling if
available, the filter pump will remain energized until the water reaches the set point temperature.
This menu is only shown if the AutoSet feature is enabled during factory setup.
a. To activate the AutoSet feature, press the MENU SELECT button repeatedly until the
AutoSet screen is displayed. Once displayed, press the UP or DOWN arrows to go
between ON and OFF. The last option shown on the display will become active.
CONTROL PANEL MENU SCREENS
To scroll through the menu screens press the MENU SELECT button to view each screen. While in
the menu screens, if no activity is detected after 15 seconds the main screen is displayed.
1. Pool Run Screen
– Displays whether the heat pump is idle, heating or cooling if the Pool setpoint
is active. This screen also displays the water temperature setpoint and the actual measured water
temperature. The Pool setpoint can be raised or lowered using the up and down arrows while this
screen is displayed. The display will automatically return to this screen after 15 seconds of push
button inactivity when the Pool setpoint is active.
2. Spa Run Screen
- Displays whether the heat pump is idle, heating or cooling if the Spa setpoint is
active. This screen also displays the water temperature setpoint and the actual measured water
temperature. The Spa setpoint can be raised or lowered using the up and down arrows while this
screen is displayed. The display will automatically return to this screen after 15 seconds of push
button inactivity when the Spa setpoint is active.
3. Heat or Cool Mode Selection Screen
–
This screen is only shown on Auto Heat and Cool
heat pumps, not on heat only units.
On these units this screen allows the operator to switch
the heat pump between heat-only, cool-only and auto heat/cool modes.
AUTOSET
OVERRIDE IS ON/OFF
POOL
IDLE/HEAT/COOL
SET=__ ACT=__
SPA
IDLE/HEAT/COOL
SET=__ ACT=__
HEAT / COOL / AUTO
SET TO - H/C/A
