Sediment filter position is at the discretion of your professional installer. As a general guideline, the sediment pre filter is
typically installed in the "pre" position (as shown above) for well-water applications. For city water applications, the sediment
filter is typically installed in the "post" position after the fluoride filter tank.
SEDIMENT FILTER INSTALLATION
Top View Filter
Blue Filter Housing
Inlet Water
Supply
Mounting
Bracket
Sediment Filter Cover
Sediment Filter
O-Ring x2
Stand Pipe
Blue Filter Housing
WATER SOFTENER ALTERNATIVE WITH NATURSOFT® SALT-FREE TECHNOLOGY
• 7
Top View Filter
Blue Filter Housing
Inlet Water
Supply
Mounting
Bracket
WATER SOFTENER ALTERNATIVE WITH NATURSOFT® SALT-FREE TECHNOLOGY
• 7
Part 1
1. Unscrew the cover from the blue filter housing.
2. Remove the plastic covering from the sediment filter.
3. Place the sediment filter onto the stand pipe in the blue filter housing and set aside.
Part 2
1. Shut off the water.
2. Attach the filter cover to the mounting bracket using the supplied bolt head screws and washers. Make sure to properly
orientate the IN and OUT to match your flow pattern.
3. Attach the mounting bracket to the wall using the supplied Phillips head screws.
4. Hand tighten the blue filter housing and then, using the supplied filter wrench, lightly snug the housing making sure not to
over-tighten (counterclockwise).
5. Determine the size of your inlet water supply line.
Note
8 •
FLUORIDE WATER FILTER SYSTEM