Pentair PENTEK PSD25PB, Installation And Operation Manual

Page: 3 / 60

3 P1063 (10-03-19)
Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should
be followed during installation, operation, and
maintenance of the Pentair Pentek* Solar Drive.
This is the safety alert symbol. When you see this
symbol on your Pentair Pentek Solar Drive or in this
manual, look for one of the following signal words and
be alert to the potential for personal injury!
indicates a hazard which, if not avoided,
will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in
this manual and on the Pentair Pentek Solar Drive.
Keep safety labels in good condition. Replace
missing or damaged safety labels.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California
to cause cancer, birth defects or other reproductive
harm.
Risk of high-voltage electrical shock .
Can shock, burn or kill if the front cover of the
Pentair Pentek Solar Drive is open or removed while
power is connected to the Drive or the Drive is
running. The front cover of the Drive must be closed
during operation.
• Make all wiring connections, then close and fasten
the cover before turning on power to the Drive.
• NEVER open the box when power is connected
to the Drive.
• Before doing any service or maintenance, or
when connecting or disconnecting any wires
inside the Drive:
1. DISCONNECT power (AC Source & Solar PV).
2. WAIT 5 minutes for retained voltage
to discharge.
3. Remove cover.
• Before starting any wiring or inspection
procedures, check for residual voltage with a
voltage tester.
• NEVER connect power wiring to the Drive before
mounting the box.
• NEVER handle or service the Drive with wet or
damp hands. Always make sure hands are dry
before working on the Drive.
• NEVER touch the printed circuit board when
power is applied to the Drive.
Risk of fire. Can cause severe injury,
property damage or death if installed with incorrect
or inadequate circuit breaker protection. To ensure
protection in the event of an internal fault in the
Pentair Pentek Solar Drive, install the Drive on an
independent branch circuit protected by a circuit
breaker, with no other appliances on the circuit.
Risk of burns. The Drive can become
hot during normal operation. Allow it to cool for
5 minutes after shutdown and before handling it
to avoid burns.
NOTICE To avoid damage to the Drive or problems
with the Drive make sure:
• Drive is correctly wired to the solar source
and motor load.
• DIP switches are configured to match motor
specification.
• Drive is installed in the shade away from
direct sunlight.
• Do not modify equipment.
• Do not use power factor correction capacitors
as they will damage both motor and Pentair
Pentek Solar Drive.
• Do not remove any parts unless instructed to
do so in Installation and Operation Manual.
• Do not use a magnetic contactor on the Drive for
frequent starting/stopping.
• Do not install or operate the Drive if it is damaged
or parts are missing.
• Before starting a Drive that has been in storage,
always inspect it and test operation.
• Do not carry out a Megger® (insulation resistance)
test on the control circuit of the Drive.
• Do not allow loose foreign objects which can
conduct electricity (such as screws and metal
fragments) inside the Drive box at any time. Do not
allow flammable substances (such as oil) inside
the Drive box at any time.
• Ground the Drive according to the requirements
of the National Electrical Code Section 250, IEC
536 Class 1, or the Canadian Electrical Code
(as applicable) , and any other codes and
ordinances that apply.
• All installation, service work, and inspections must
be done by a qualified electrician.