Pentair PENTEK PSD25PB, Installation And Operation Manual

Page: 17 / 60

17 P1063 (10-03-19)
Troubleshooting - Indicator Lights
There are four LED lights on the Pentair Pentek* Solar Drive. The indicator lights and their
definitions are listed below.
AC LOAD SOLAR WARNING MODE
(Green) (Yellow) (Red)
ON ON ON - Unit is OFF
FLASHING OFF OFF - Startup
ON OFF OFF - Running
OFF FLASHING OFF - Standby
OFF OFF FLASHING - Float Switch
OFF OFF ON - Over Temperature
ON OFF ON - Power Deration
FLASHING OFF FLASHING - Over-current
OFF FLASHING FLASHING - Short/Open Circuit
FLASHING FLASHING FLASHING - Dry Well Protection
OFF Mode Pentair Pentek Solar Drive toggle switch is in the OFF position.
Startup Mode Pentair Pentek Solar Drive is in the process of starting the motor pump.
Running Mode Pentair Pentek Solar Drive is running the motor pump.
Standby Mode There is not enough power from the solar PV panels for
Pentair Pentek Solar Drive to start the motor.
Float Switch Pentair Pentek Solar Drive is turned OFF as a result of input from one
Mode or more external sensors that are connected to the digital input.
Over Temperature Pentair Pentek Solar Drive stops operation when the temperature
Mode inside the unit exceeds 80°C/176˚F.
Power Deration Pentair Pentek Solar Drive still operates but with reduced power
Mode throughput due to increased operating temperature, or if a load
is connected with current higher than over-current protection
DIP Switches 6 and 7.
Over-current Pentair Pentek Solar Drive stops operation when it detects high current
Mode on the motor terminals. This can also be due to a short circuit event if
the unit is mis-wired. Requires manual restart by cycling power to
the unit.
Open Circuit Pentair Pentek Solar Drive will not start operation if the motor wiring
Mode does not align with DIP switch configuration.
Dry Well Pentair Pentek Solar Drive detects dry well condition, and ceases pump
Protection operation, which is restored after 30 minutes. If dry well indication
appears faulty, check that over-current protection DIP Switches
6 and 7 are configured correctly.