Pentair NOCCH, Manual, Page: 27 / 128

23
GB
Line n.1 TRANSLATOR
Non modifiable description
Line n.2 VALUE MAXIMUM BAR XX
The maximum value of the pressure transducer must be entered. Normally in our standard groups a transducer 0-5V 0-10 bar is
used, therefore value 10 must be entered for this transducer.
N.1 line ACCESS MENU
Description non modifiable
N.2 line TOTAL XX
• YES: permits to access menus 8 - 9 - 10
• NO: disable access to menus 8 - 9 - 10
ENTE R
ENTE R
ENTE R
Menu 6 regulating of operational parameters is accessed to by pressing key (20).
Press key (20)
Press key (20)
for about 2” until the following message will be displayed: appears the menu
2. MENU FOR REGULATING OPERATIONAL AND CALIBRATION PARAMETERS
The access to this menu is direct from configuration menu 1, otherwise proceed as follows:
check that all drawings are closed or that the water distribution network is cut. Bring the main switch to position I (ON).
While the small bell gives out some beeps, press the key, until the following message will be displayed:
M
A
SET POINT
Bar 05.0
6a
TRANSDUCER
VALUE MAX Bar 10
4
MENU ACCESS
TOTAL YES/NO
5
MANUAL FUNCTION
Bar 05.0
PROG MENU.
THRESHOLD
INVERTERS
6