General Safety / Assembly
3
risk of electric shock.
If your basement has
water or moisture on the floor, do not walk on wet area
until all power has been turned off. If shut-off box is in
basement, call electric company or hydro authority to
shut-off service to house, or call your local fire department
for instructions. Remove and re place system. Failure to
follow this warning can result in fatal electrical shock.
risk of electric shock.
Do not handle pump
or pump motor with wet hands or when standing on wet
or damp surface, or in water. Always disconnect the pump
and switch from the electrical power source before doing
any maintenance.
16. Pump water only with this pump.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
assemBly
Steps 1 and 2 (See Figure 1)
Step 3 (See Figure 2)
Step 4 (See Figure 3)
Install the discharge pipe hand-tight plus one-half turn.
Step 5 (See Figure 4)
Place the pump in the basin as shown. Align the discharge
with one of the threaded ports in the cover.
Step 6 (See Figure 5)
Turn the cover upside down and ‘lay in’ the basin gasket
as shown.
1
Figure 1
2
Figure 2
3
Figure 3
Inlet
4718 1004
Pump
Basin
1 " NPT
Discharge
1 " NPT
Vent
1
2
1
2
Figure 4
4719 1004
Locating
Cleats
Figure 5
