9
KREEPY KRAULY
®
Suction Side Pool Cleaner Installation and User’s Guide
KREEPY KRAULY
®
Suction Side Pool Cleaner Installation and User’s Guide
PROBLEM
CORRECTIVE ACTION
Cleaner is not moving or not pulsating.
Check to be sure that the main drain and all suction lines are closed, except for the
suction line to which the cleaner is attached.
Check for debris in the filter or pump basket.
Check for debris in cleaner flapper. Debris may prevent flapper movement or restrict
flow. See page 8 for instructions.
Pool pump and filter system may be too small (incapable of providing 25 gallons per
minute water flow). Consult your pool professional.
Cleaner stays in one end of the pool.
Check the return line water flow and redirect as necessary with an eyeball diverter.
Refer to page 7.
Check that hose is long enough to reach to end of pool. Refer to page 6.
Check that the cleaner has proper hose balance. Refer to page 6.
Cleaner stays on the main drain.
Check to be sure that main drain is closed. May need assistance from a pool
professional.
Check to be sure a main drain grate is installed.
If main drain is not flush with the pool floor, consult your pool professional.
Cleaner slows or stops and air bubbles enter
the pool at the return line.
Find and correct the air leak that is causing the pump to lose its prime:
Check the hose to be sure there are no leaks.
Check the vacuum connection. It should be submerged so no air enters the system.
Check the pump basket lid for looseness, cracks, and worn or missing O-rings. If
you need assistance, contact your pool professional.
Cleaner pulls air from, or remains at the water
surface.
Check that dive float mechanism is operating freely and the dive float restrictors are
in the desired position. See page 3.
Check the automatic regulator valve for its proper installation and ensure it is not
clogged with debris.
Make sure the water level is at least 3 inches below the pool deck.
Check that cleaner is operating at the proper speed of 8-12 feet per minute.
Cleaner stays at the shallow end steps.
Check the return line water flow and redirect as necessary with an eyeball diverter.
Check the automatic regulator valve for its proper installation and ensure it is not
clogged with debris.
Check that hose is long enough to reach the furthest point of the pool, including pool
steps. Check for proper hose balance and cleaner is operating at the proper speed
of 8-12 feet per minute.
Check to ensure the dive float mechanism is operating freely and the dive float
restrictor tab is in the up position. See page 3.
If cleaner gets stuck on pool obstructions
such as a safety ledge, ladders, steps, swim-
outs, benches, etc.
If the cleaner gets stuck under your pool ladder, install a Ladder Guard (P/N
K12330) according to the instructions contained in the packaging. (These
accessories are available for purchase from your Pentair Aquatics dealer.)
TROUBLESHOOTING
Because of the individual characteristics of your pool, some additional adjustments may be required to get the best
performance from your Kreepy Krauly
®
Suction Side Pool Cleaner. Use the following information to resolve possible
issues
.
