1
KREEPY KRAULY
®
RACER
™
Pressure Side Pool Cleaner Installation and User’s Guide
OVERVIEW
Overview
The RACER™ Pressure Side Pool Cleaner moves
through a sequence of straight, right and left turns
helping to increase pool coverage, vacuuming and
scrubbing your entire pool.
•
For continuous uninterrupted cleaning, the cleaner
will go into reverse mode about every two minutes,
which allows it to efficiently clean the entire pool.
Note: Before you install and operate your cleaner,
read through these important guidelines:
1.
Always disconnect the cleaner from the pool wall
when cleaning or back washing the pool filter.
2.
After cleaning or back washing the filter, let the
filtration system run for at least five minutes before
reconnecting the cleaner.
3.
New plumbing lines should be flushed out before
installing the cleaner.
4.
The cleaner should not be used to remove plaster
dust in new pools.
5.
Always remove the cleaner before swimmers enter
the pool.
6.
Always handle the cleaner with care.
7.
Always pick up the cleaner by the handle,
especially when lifting the unit out of the water.
8.
Do not handle the cleaner while it is operating.
9.
Always remove the cleaner from the pool before
chemical shock treatments (super chlorinate). As a
rule, any pool water that is unsafe for swimming is
unsafe for the cleaner.
10.
Carefully cut the feed hose following the
instructions on page 4.
11.
By following these simple guidelines, you can help
protect against injury and prolong the life of your
cleaner.
12. Refer to “Important Warning And Safety
Instructions” on pages ii - iii for additional
installation and safety information.
13. Before you install your RACER pool cleaner:
If there is a chlorinator, solar system, ozone
generator or air inducing equipment installed,
contact Technical Support at 1-800-831-7133.
Night Cruize
®
LED
1. RACER Cleaner Head
2. Debris Bag
3. Sweep Hose (not needed
in most pools)
4. Feed Hose Assembly - Not
shown (3-10 ft. sections)
5. Wall Fitting
6. Wall Adapter
7. Debris Seal
Note:
The cleaner system is delivered
with debris seal installed inside of
cleaner head.
8. Flow Gauge
ESP
AÑOL 20
FRANÇ
AIS 43
ENGLISH
Cleaner Components
1
2
5
6
8
7
3
