9
KREEPY KRAULY
®
RACER
™
Pressure Side Pool Cleaner Installation and User’s Guide
ESP
AÑOL 20
FRANÇ
AIS 43
ENGLISH
Adjusting the Sweep Hose Regulator when
Sweep Hose is Installed
The sweep hose operates in a gentle sweeping motion to
clean debris from hard to reach corners of pools.
Note: 1. Do not adjust the sweep hose regulator while
cleaner is operational. This may damage cleaner.
2. The sweep hose must be used to adjust the
sweep hose regulator.
1. If you do not plan on using the optional sweep hose, there
is nothing more you need to do. To attach the optional
sweep hose to the cleaner and open the sweep hose
regulator, proceed to Step 2.
2. To attach the sweep hose to the RACER™ Pressure Side
Pool Cleaner, line up the lock tabs on the inside of the
sweep hose fitting (small round fitting on the end of the
sweep hose) to the locking slots on the cleaner’s sweep
hose regulator.
See figure 17
.
3. The sweep hose regulator comes from the factory in the
closed position. To open the sweep hose regulator, push
the sweep hose fitting onto the sweep hose regulator.
When it can not be pushed any further turn the sweep
hose fitting
clockwise
until it stops (about 45 degrees).
See figure 18.
Pull out on the sweep hose fitting and
the fitting will lock into place.
4. To remove the sweep hose and turn off the sweep
hose regulator, hold the sweep hose fitting and turn it
counter-clockwise
until it stops (about 45 degrees).
See
figure 18.
Pull the sweep hose fitting from the sweep
hose regulator and store it in a safe place.
Sweep Hose
Regulator
Sweep Hose
Sweep Hose
Fitting
To Close
To Open
Open
Position
Closed
Position
Locking
Slot
Sweep Hose Regulator
Lock Tab
Sweep Hose Fitting
Figure 17.
Figure 18.
